Sensorsoft ST6105J Manual de usuario descargar pdf (Pagina 20)

Sensorsoft Remote Watchman Express/Client User Manual

 Delay before fail retry: This setting controls the length of time in seconds that the

software will wait after an e-mail message fails before attempting to send the message

again. Use the up and down buttons to make changes to the setting.

Events: Each event type required must be specified individually. A check mark in the Enable box

beside the Event indicates that a message will be sent for that event. Ensure that you have

selected the correct event type before completing the following details. Please note that you must

click the Apply button before highlighting a new event type, in order for your changes to be

saved. Events are arranged in order of numerical priority from lowest (top) to greatest (bottom).

The Retry state is considered the highest priority.

Send message at a scheduled time: By selecting this event you can set up the day of the week

and time you would like a scheduled e-mail message to be sent. If a scheduled message has been

sent, its time specification must not be reprogrammed until 10 minutes after the event occurred.

Figure 7b

 Recipient(s) E-mail Address (To:): This field must contain a valid e-mail address. Use a

comma between each e-mail address.

 Subject: This field contains the subject heading of your alert e-mail.

 Priority: Select if the message is to be sent with High or Normal priority.

 Message: Type in the message you want delivered to the recipient. See Appendix C -

Using Dollar ($) Variables in your alert messages, for details on how to customize your

alert message. If you are sending an email to a pager or cell phone be aware that your

provider may impose limits on the size (number of characters) of the message and may

truncate longer messages.

Send Test Message: This button launches a test e-mail message. The test message uses the

currently selected Alert Event settings. A “Testing - …” preamble is affixed to the message so

that the recipient(s) know that a test is in progress and not an actual alert or scheduled message.

Alert Interval: This setting controls the amount of time (in minutes) between e-mail messages

when in an alerting state. Use the up and down buttons to make changes to this setting. The

normal state restored alert and scheduled message events are issued only once and are unaffected

by this setting. If an event of higher priority occurs (see Events above) and the event is enabled, a

message will be sent even though the Alert Interval period did not expire.

OK Button: Click this button to activate/save your changes and close the window.

Cancel Button: Click this button to abort any changes and close the window.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 41 42

Sin comentarios

Sensorsoft ST6105J Manual de usuario Pagina 20